DVI7911 Junction Board

Last modified by Michael Sibayan on 2014/11/14 09:07

Overview

The purpose of this board is to combine cabling of five (5) Davis Instruments anemometers into a pair (2) of 8-conductor cables and handle external circuitry required for data acquisition with these devices. Each Davis Instruments anemometer requires an excitation voltage of approximately 3.3 VDC and a pull-up resistor on the relay output of cup anemometer. A simple diagram of the internal circuitry of the Davis Instruments device is shown below:

DVI7911_Internal_Circuit.png

The normally open single pole single throw (NO-SPST) relay is actually a reed switch that closes for approximately 4ms when the cup anemometer passes the correct position. The potentiometer wiper is controlled by the wind vane. In order to monitor the junction box provides excitation regulation at 3.3VDC (from a 5VDC source), and pull up resistors for the reed switch. Below is the circuit diagram used on the junction board:

DavisAnemometer-JunctionBox-Circuit.jpg

Images of the board, layout, and pin assignments

Pin assignment:

Plugs 1 through 5

  1. N/C
  2. +3.3VDC
  3. Potentiometer output
  4. Reference (Ground)
  5. Relay output
  6. N/C

Plug A

  1. Device 1 relay output
  2. Device 1 potentiometer output
  3. Device 2 relay output
  4. Device 2 potentiometer output
  5. Device 3 relay output
  6. Device 3 potentiometer output
  7. Device 4 relay output
  8. Device 4 potentiometer output

Plug B

  1. Device 5 relay output
  2. Device 5 potentiometer output
  3. N/C
  4. N/C
  5. N/C
  6. Voltage monitor (output of regulator)
  7. +5VDC (supply voltage)
  8. Reference (Ground)

DVI7911_JunctionBoard.JPG
DVI7911_Board_Top.png
DVI7911_Board_Bottom.png
Davis-Anemometer_JunctionBox.bmp

Tags:
Created by Michael Sibayan on 2014/11/14 09:07

This wiki is licensed under a Creative Commons 2.0 license
XWiki Enterprise 6.0.1 - Documentation